Recent content by Chris Luke

Do it, I got 22" chromes on mine and it looks great! :supercool:

maybe you guys should drive up to Canada and have a meet! haha

Yeah I'm also getting a tune for that. Will need one for sure. I will have some pics up after the install is all done. My throttle body won't be in until mid January though. :supercool:

I have the KN cold air intake right now, Do you think you can just buy a rubber piece to make it work on the dual butterfly?

So the shop foreman at the Ford dealership that sells Ford racing products said that the Ford racing intake manifold will fit under the hood, I also got the specs for it, its about 9 inches high, and I measured the stock intake and its about the same, so it will fit, so now I have purchased both...

I guess I better figure that out if the intake will fit, bc I am planning to buy the intake and throttle body, already have the cams installed, anyone else have hot rod cams installed in their ST? would like to know if the same roughness characteristics that I have is the same or not

Talked to the mustang shop in calgary and they did that on a harley F150 they said they had no issues, tuner in Edmonton said they don't recommend it, talked to henson performance (they do a shit load of harleys) The guy said that the tuner does not recommend this, nor does he like it, but in...

I installed Ford Racing hot rod cams in mine, shakes more and had to bump the idle speed up to reduce the shake, have some minor issues, being jerky and some CEL's but it is an improvement, was told heads arent worth the money, bc the stock heads are pretty good. I still need to dyno tune my...

that happened to me too, and it fried my AWD module

Everything worked out, had some issues with the tune, so got a tune from torrie, but then the chk engine light comes on, saying misfire on cylinder #1, but thats due to the cams shaking so much, the truck shakes more in idle so bumped up the RPM in gear to 950 to minimize it, going to have to...

yup yup this happened to me, it fried the AWD module in the tranncky, but lucky me got that covered under warranty, but had to for the mechanic to soder the wires back, and braced the intake tube, hunk a junk!

oh ok that doesnt seem that difficult at all, thanks Yeah ford racing, with exhange and shipping i paid close to 1000 bucks, it's installed but the motor is running rough, so the tune may not be right, waiting on a new tune,bc the tune wasnt done for my Zabtek throttle body, but the tuner...

what did you do to make your side vents functional?

yeah i tune to go with it, got the cams and tune from BBR

Getting some hot rod cams installed today, hoping this will give my Adrenaline some more throttle response and GRUNT!:banana: