Recent content by jaydawg74

Excellent idea! Thanks Todd!

How would I torque the axle nut with the truck in the air? Is there a way to lock down the hub so it doesn’t spin when doing so? Also, I never use air tools when I work on the trac, except to take off the lug nuts!

I’ve always torqued to 185 ft lbs! I’m just curious if bad cv axles could cause it. I just replaced both sides this past week. As well as both tie rod ends as the boots were pretty wasted. Also noticed that my lower control arm bushings are looking pretty bad. I’ll probably just replace both...

These ones are SKF! I’ve had Timkin bearings fail in under 2 years too.

hey guys, what would be causing premature whelp hub failure? My front right is out again after I just replaced it probably 4 months ago. I seem to go through hubs a LOT on the trac, like every 2-3 years. trying to narrow down why. Thanks!

Update: changed the T-stat last weekend and that fixed it. Thanks guys.

Yes, getting cold here in Reno Nevada! Thanks guys!

Hey guys, I'm having an issue with my engine temp gauge. The gauge is normally at the halfway point, but lately it stays low, like no more than a quarter way. There doesn't seem to be a problem with heat, it still blows out nice and hot. What could this be? Thanks in advance!

Hey guys, when I'm in 4 wheel drive (high), my steering radius seems to drop about 30%. Like the wheels just won't turn as far as in 2 wheel. Is this normal or not? What should I do to correct it or what needs replaced? I'm driving a 2001 ST. Thanks guys!

The fuse looks okay. I don't have a meter, maybe I'll get one. Today, my "check fuel cap" light came on. I know that the cap is good, I just replaced it a few months ago.

Hi guys... Have any of you gotten this Check engine code? P1451 Evap system canister vent solenoid circuit malfunction. From my searches so far it seems to be an electrical issue. I searched and could not find any frayed wires or anything. I did recently change the radio from the stock...

Go to the "projects" section on the left of the screen. Then go to "maintenance". There is a project there you can follow to replace your half axle (cv joint).

Try Ebay. I found one for a friend of mine for his mazda on there.

Todd, I REALLY wish you'd made a project for the rebuild! I think mine may be going out too and I'd like to rebuild it. I remember you had a thread on it, maybe you could post the link or make a project?

I have a velcro cover on mine. Had it for about 10 years now and it's held up great! I did replace the velcro about 3 years ago. I can't see myself ever going with any other type of cover!