mookie
Well-Known Member
This was posted by Pepper K496 in another thread: :supercool:
Happy modding!
Pepper K496,8/7/2010 12:53 PT
Fender vents weren't that difficult. Just carefully pry the vent housing from the fender - I used a plastic spackling tool, wide flat and very thin. Once its separated, you can pop the black plastic backing off and replace it with some mesh grill or something similar. Mounting the mesh may have been the hardest part. I cut it so the mesh would slide over the existing mounting tabs nice and snug.
There are a few pieces of thick tape covering pre-drilled holes once you look inside the fender. If you remove the tape you'll find out that there is yet another "inner" fender that still prevents the vents from actually functioning. A hole saw from the inside of the engine bay fixes that. Voila!
Happy modding!