Search results

2 OEM tail lights for a 2001 job 2 ST. Good condition> You pay the shipping & they are yours

I have a 2001 job 2 that is missing out badly. I just had the plugs changed and the wires tested. The mechanic says he thinks the #5 5 cyl. has a sticky valve. I changed the oil and added Sea Foam and it cleared up but was back within 3,000 miles. I changed it again and added Sea Foam again but...

does anyone have instructions on replacing the power steering pump on a 01 job-2? I know the stock pump is weak and needs to be replaced with one for an Explorer. But which one?

I have a factory amp. set up in my 01 job 2 ST. One of the large speakers in the back panel is making a low poping noise. Do I have a speaker problem or an amp problem?:(:unsure:

My heater controls are acting up. The heat stays on high even when the control is turn all the way down, but not all the time. Is the switch bad?:unsure:

I just finished changing the oil & filter on my 01 Trac and got to wondering. Does anyone know of a larger filter that will fit.? I used the PH-8A ford filter on a Audi I once owned and it fit fine with a much larger capacity. There is plenty of room under there.:unsure:

I have a problem with my daughters 98 Winstar van. The engine RPM's run up and down and it dies at stop lights, but not all the time. Could it be the same vacuum leak that we have with out Tracs? Any help or opinions would be appreciated.:unsure:

I plan to install new speakers this weekend. Can anybody tell me how to tell negitave from positive on the old speaker wires? It may not be a problem, but I want to be sure before I start.:unsure:

I cleaned her up & polished the wheels Wanted to see if the new pics I sent to my library where too big or OK.[Broken External Image]: [Broken External Image]: [Broken External Image]:

Does anyone know any tricks on changing the plugs on this beast? The front 3 are going to be simple, but how do I get to the back ones? :unsure:

Can anyone tell me if the EPC adjustment is the same on a 98 Ford Winstar Van front wheel drive? I am going to the tranny fluid/filter change along with the drain plug on my daughters van soon and I would like to improve the shifting a little.:unsure:

Wayne I sent you mail at [email protected]:)

Todd, You don't need to send me a check. Remember, you sent me a couple of samplers for your hot scauce with the new brackets?:)

I would like to take my old wheels and tires 16" and put them on my daughter's 92 Ford F-150. Do they make wheel adapters for such a install? If so where to get them and how much? :unsure:

:)Finally with much help from Todd Z and others here She is. All clean and Waxed and ready to go. [Broken External Image]: [Broken External Image]: [Broken External Image]: [Broken External Image]: [Broken External Image]:

Finally with Todd Z's help I have some pics after washing & waxing my 01 4X4. How do I get them to post in this message? I clicked on the icon and picked one out but how from there?:wacko::unsure:

Sent you another E-mail.

:);):unsure:

I am going to have to get new tires soon. I am running the stock 255/70R 16. I have done the shackle/TT lift and installed 4-1 1/4" wheel spacers. I would like to go with a taller but not too much wider tire to help in the MPG area. Any ideas? :unsure: