Recent content by Jose Santana

Is gen 2 a 2003? I have not been here in a while but I have a 2003 bed extender

ANYBODY???? Todd?

A few questions #1 Do the seats all have to come out to change these? #2 Where do you buy replacement bolts if they snap? #3 Is this something a normal backyard garage guy can do? Joseymack

I think your answer is YES buy the camber bolts for alignment. If you truck is like my 03 I found when i redid my upper control arm with Moog the factor cambers were factory set with a pre drilled offset. I had to buy the cam bolt and casters to get it to align properly... Cheap money Joseymack

Did you have to take out the warrior shackles? I need to add a leaf but i would like to keep my warriors becuase I no longer have the stocks. joseymack :back2topic:

Ok folks I been here for a long time and I have read alot on the leaf springs. but just where would i purchase a set of quality leaf replacement springs? My trac sags bigtime when i put on my popup camper or trailer, with mulch, wood or whatever. Way more than i think is good, and way more than...

No richard it is not the celcius farenheit thing, they both are way off,,,,it is more what Brian says. I will check the ambient air gauge in front of radiator bracket and see if that it it. Joseymack

My temperture reader above the rear view mirror is way off. if there a way to recalibrate this thing? Where is the therma couple measuring. It is plain out wrong.

Does the Harbor Frieght sucker get all the fluid out. How many quarts would be required for the front diff? How many for the rear diff? Josyemack

Just did a rack change and I think it was a bit tougher than originally thought. I think a second time around would be easier but be prepared for some trouble with the highpressure hose and low pressure house. It is a press fitting which goes from the pump into the pinion. Mine was rusted up and...

Funny Todd the air I guess is all set. I filled the reseviour once and it took it in, bubbling all the way. I topped it off and it seems to be all set??? I did go in and reseat the rack on the frame and torqued it to 148foot/lbs and I torqued the pressure lines to 15in/lbs.... They still swivel...

Oh I am absolutely getting an alignment and 4 new tires. I changed out the control arms ball joints and tie rod end too. My question was regarding the rack itself. Yes it came with new bushings but I wanted to be sure it was correctly seated within the frame. It self aligns seems to be what I am...

Changed a leaky rack and pinion on my "03". Test drive revealed my whole rack would shift around a bit during turning, left ot right. I checked torque and crancked it up to 148ft/lb... It really is tight but I question it because it seems the bushing are really squeezed. This is really tight is...

Love my A.R.E check out picks

I'v seen you screen name for years and feel sorry for your loss.... God Bless