THrottle position sensor

[Jim Barnett]

On a Gen 2 do you need to pull the throttle body to change the sensor? I know it

Is on the back and could be a little challenging but is better to pull the throttle body.

Thanks

Jim

 

[Todd Z]

Yes, because the screws are held on there with a blue lock tight, They can snap if twisted wrong and its way better to remove the TB.....



Its easy to remove the TB..... <------------------Projects section.



Also check the wiring because I have seen the TPS wiring insulation fail and cause issues.



Todd Z

 

[Jim Barnett]

You were right about the wiring it is brittle right were it comes out

Of the connector I took some Liguid tape and coated them if that

makes a difference I'll wire in a new connector.

Thanks

Jim