Can Trac
Member
I'm going to replace the front SB on my 05 with an ADDCO,, is it worthwhile also changing the end links to MOOG?
~thanks
~thanks
Sway Bar End Links
- Thread starter Can Trac
- Start date
Help Support Ford SportTrac Forum:
Yes, because the MOOG or equivelent use stronger bolts; but also use a metal sleeve, that the bolt goes through, between the two inner bushings instead of plastic ones. I say equivelent because I was curious and asked Kragen if I could look at the Enk Links for the ST from their supplier, and they were pretty much the same concept.
- Joined
- Sep 21, 2003
- Messages
- 22,366
- Reaction score
- 752
- Location
- Long Island, NY
- What engine do you have?
- V8 engine
- What year is your Sport Trac?
- 2010
- What Generation is your Sport Trac?
- 2n Gen Owner
THE new ADDCO bar comes with NEW end links and all the hardwear...
JUST a word of caution, the brackets do not line up on the frame, you have to make the holes larger to give the bolts a straight shot or you could wind up cross threading the bolts or snapping them..
Todd Z
JUST a word of caution, the brackets do not line up on the frame, you have to make the holes larger to give the bolts a straight shot or you could wind up cross threading the bolts or snapping them..
Todd Z
As Todd said, the Addco bar comes with all the hardware needed to install it.
The bar is so big, it is almost a little too big for the stock bracket mounting holes. We took a hammer and tapped the bracket a little smaller where the bolts would line up, but the bushing still fit.
Tom
The bar is so big, it is almost a little too big for the stock bracket mounting holes. We took a hammer and tapped the bracket a little smaller where the bolts would line up, but the bushing still fit.
Tom
