Peg Leg
Member
My 05 ST wil not start after changing fuel filter, has excess of 60psi of pressure measured fom the engine side of new fuel filter(reason I changed filter was to measure fuel pressure to make sure rough idle wasn't fuel pump or filter causing a P0190 code) The fuse is good and replaced, filter arrow is pointing toward engine. I followed the Project directions to the tee after getting the right fuse layout from fellow member. What could I have screwed up, I cranked it many time, so I'm sure it's primed. I even took the fuel line off again and measured pressure and still got above 60 psi when cranking.
Any ideas
PL
Any ideas
PL