Rahul Sharma
Active Member
I have the main headlight project printed out and ready to go for this weekend, but i just wanted to know if i could do the factory (OEM) corners that i currently have on the trac in the same way - baked and seperated in oven?
I'm not a noob on doing this work, i have done this on another vehicle (oven) so it's not a difficult undertaking for me, but i don't want to do just the headlight and then have the factory corners....that would look bad IMO.....
Thanks in advance as always!
I'm not a noob on doing this work, i have done this on another vehicle (oven) so it's not a difficult undertaking for me, but i don't want to do just the headlight and then have the factory corners....that would look bad IMO.....
Thanks in advance as always!