Drivers door outside handle doesn't open consistently. Locking mechanisms work fine, key, fob and keypad. But when unlocked it doesn't always open. Seem as though the warmer it gets the more it won't open. Found a plastic connector on ebay, that may fix it. Haven't taken my door panel off...
The BEST thermostat housing is produced by Simmons Autosports. It is cast aluminum and produced here in the states. I installed one on my Sporttrac at Thanksgiving and had to order one for the wife's Mustang last night. Jonathon is a good fellow and has done what Ford should have. You can...
The thermostat housing leak can be very hard to diagnose. The most important clue is the leak next to the oil pan. Let it get hot and look to see if coolant is running down the front of the block. When the housing went in the Mustang it was easy to spot. There is more open space to see in...
First Eddie, all new auto brake rotors are designed to last as long as the pads do. The dealer makes more money that way. Secondly drilled and slotted rotors are the only way to not suffer from having to change rotors with pads. My ST will need brakes soon and I will get my drilled & slotted...
I figured the difference out when I looked at the listing. The gen 2 ST uses the drive by wire TB. I have already removed the stupid coolant line. I want one of your modified TB's for the Mustang. Next spring look to be in position to get one. I have an S&B CAI and TB spacer on it with a...
Good day, Todd
I have 2 05 Fords, A v6 Mustang coupe and the ST. The Mustang is drive by wire, and as you know the ST isn't. I haven't had the TB off the ST yet, only had it a couple months. Is the throttle set up the same then? I would definitely like to have this one for the Mustang...
I need the cover for the jack storage compartment behind the rear seat passenger side. One of the pivot tubes is broken on my 05. I have the grey interior but color is not important. Should fit in the usps large flat rate box. What will you take for it? I will check back on the site early...
I am in need of atleast one of the spring clips that hold the bed extender in place. I really don't want to buy the bracket because I am missing one clip. Anybody have one or a template for making one?
Thanks,
Richard