Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
SportTrac Discussion
Electrical
Multifunction, turn signal replacement
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Ford SportTrac Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Fudged Undies" data-source="post: 806061" data-attributes="member: 57548"><p>There are roughly five screws holding the steering column cover on. You access them from the bottom of the column. If you have tilt column, you have to remove the lever by turning it counter-clock wise (just screws out). Once removed, the bottom half of the cover should/will come off, the top is more difficult to remove/replace and if you don't have a tilt column, try to leave it in place. The multi-switch is held in place by two screws, remove them, remove the wire harness and your done. Reverse the steps to replace.</p><p></p><p></p><p></p><p>If this were a project it would get 2 wrenches on a worst case scenario. Take your time, and you should finish in an hour or so.</p></blockquote><p></p>
[QUOTE="Fudged Undies, post: 806061, member: 57548"] There are roughly five screws holding the steering column cover on. You access them from the bottom of the column. If you have tilt column, you have to remove the lever by turning it counter-clock wise (just screws out). Once removed, the bottom half of the cover should/will come off, the top is more difficult to remove/replace and if you don't have a tilt column, try to leave it in place. The multi-switch is held in place by two screws, remove them, remove the wire harness and your done. Reverse the steps to replace. If this were a project it would get 2 wrenches on a worst case scenario. Take your time, and you should finish in an hour or so. [/QUOTE]
Insert quotes…
Verification
Post reply
SportTrac Discussion
Electrical
Multifunction, turn signal replacement
Top