Robert Caffyn
Well-Known Member
I just order all LED's for outside of truck, I also included load resistors. I need the colors of the wires for the LF, RF, LR and RR turn signals so I can put the resistors across them. Thanks.
LED bulbs
- Thread starter Robert Caffyn
- Start date
Help Support Ford SportTrac Forum:
- Joined
- Feb 27, 2009
- Messages
- 5,639
- Reaction score
- 516
- Location
- Kailua-Oahu, Hawaii
- What engine do you have?
- V6 engine
- What year is your Sport Trac?
- 2005
- What Generation is your Sport Trac?
- 1st Gen Owner
Bob, try one of these links.
http://www.bbbind.com/free_tsb.html
http://www.bbbind.com/free_tsb.html
Bob Floyd
Active Member
Its a lot easier to put a electonic led flasher in one and done.. I did my 03 and it works like a champ and it does what it is supposed to do cut down on amps to run all your lights
Robert Caffyn
Well-Known Member
Yeah, unfortunately the flasher is controlled by the ECU, there is no module on my 2010. Same issue with my 2008.
Gavin Allan
Well-Known Member
If the flash is controlled by the ECU, do you really need the load resistors? They are needed because the old-fashioned mechanical flasher doesn't heat up enough to work properly with the lower current draw of the LEDs. Maybe the ECU doesn't care about the lower current draw of LEDs?
TrainTrac
Well-Known Member
Any update on this? Were the resistors needed, or did the ECU take care of the lower resistance in the LED's?
