Chris Ward 2
Member
Help, I put a very small dent in the drivers side back door and need to remove the inside door panel to see if I can get it back out. How do I get the panel off?????? :soap:
HELP Please
- Thread starter Chris Ward 2
- Start date
Help Support Ford SportTrac Forum:
- Joined
- Feb 27, 2009
- Messages
- 5,639
- Reaction score
- 516
- Location
- Kailua-Oahu, Hawaii
- What engine do you have?
- V6 engine
- What year is your Sport Trac?
- 2005
- What Generation is your Sport Trac?
- 1st Gen Owner
<--- Found in Projects section. Both front and rear panel removal shown.
Last edited by a moderator:
- Joined
- Feb 27, 2009
- Messages
- 5,639
- Reaction score
- 516
- Location
- Kailua-Oahu, Hawaii
- What engine do you have?
- V6 engine
- What year is your Sport Trac?
- 2005
- What Generation is your Sport Trac?
- 1st Gen Owner
Last edited by a moderator:
I would bite the bullet and take it to a restoration place and get a estimate and then to a reprable body shop for another estimate. You make a costly mistake with your door panel and you may regret starting that job. The old cars and trucks just remove several Phillips screws and you got it ,that is after removing the door handles . With the new vehicles they have a whole new way of doing things . Or if you insist get a manual for instructions that a body shop might use. Good luck .
