Recent content by Parker Richards 2

Ford SportTrac Forum

Help Support Ford SportTrac Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    New transmission but no reverse or drive

    Hey guys just to update. Set the tranny back and got a new one. I went through and double checked all the wires and found a little crack so I repaired it. New transmission is in and shifts like a dream. I think what cause the crack was the wires weren't hooked into the plastic mounts on the...
  2. P

    New transmission but no reverse or drive

    Thanks Rich, Well the newly installed tranny has mercon v in it. I took it to for and had them reflash the pcm, which didn't solve my problem. They obviously said the new remanufactured transmission that was installed needed to be removed and rebuilt. Then I took it to aamco for it to be...
  3. P

    New transmission but no reverse or drive

    Well pcm reflash did nothing. Still no reverse and od only works after going to manual second. The company that sent me the transmission says it sounds electrical, Ford tried to tell me that those gears were gone in my transmission. Except when I discount the solenoids I have reverse. I'm so...
  4. P

    New transmission but no reverse or drive

    Hey Todd, sorry yes it is a 2001. I have been playing with it all day. I disconnected the solenoid harness and I got reverse. I also was laying under the truck and had someone shift it through the gears. In all the gears I can hear a soleniod buzz. In drive and reverse it buzzes for a minute...
  5. P

    New transmission but no reverse or drive

    Hey all! I just finished putting in a remanufactured transmission. I filled her up with fluid and went to back out of the driveway and realized I have no reverse, so I went from reverse to neutral to drive and have no drive. When I go from d to second it kicks in then when I go back to drive I...
  6. P

    Big??? Electrical problem

    Hey Mike, Do you know how water got into the pcm? I think I have had the same issue. My tranny only produces codes when it is raining or the snow has melted.
  7. P

    Every single part! CHEAP

    Jason, I might have 4x4 control module that I bought to replace mine but it turned out that wasn't the problem. How much are you looking to spend?
  8. P

    p0765 won't go away

    Hey all, So the other day I was driving after a pretty good amount of rain and the light popped on. Any idea if it is a short and where that short might be? It seems to only come on when there is wet weather. thank you for your help!
  9. P

    p0765 won't go away

    Hey all, So very strange update. Been driving around and had to keep clearing the codes. But it's been about 3 weeks since I last had to clear anything. I'm baffled the tranny is shifting perfectly. No codes, no slips, nothing. Thanks for all the advice and recommendations. I have no exact...
  10. P

    p0765 won't go away

    Thanks for the responses. I've gotten it now were the light will go off and stay off for a while and then randomly after shutting the truck off and restarting it will pop up. I'll reset and drive around and nothing but it is reading it as pending(but only sometimes). Could this be a short? Any...
  11. P

    p0765 won't go away

    Thanks for the responses. I've gotten it now were the light will go off and stay off for a while and then randomly after shutting the truck off and restarting it will pop up. I'll reset and drive around and nothing but it is reading it as pending(but only sometimes). Could this be a short? Any...
  12. P

    p0765 won't go away

    Thanks Todd. I ohm checked the old one and it seemed to test ok. Maybe I'll order a new one and drop the pan again. It's weird when I clear the codes the light doesn't come on for a while. Could it be internal?
  13. P

    p0765 won't go away

    Hey Everyone, I've got an 01 Sport trac with its second transmission in it. I am having issues resolving this code. P0765. I have changed the valve body and harness. Now I am getting the 2nd and 5th incorrect ratio codes. Am I just SOL and going to have to either rebuild or install a reman...
Top