1. Welcome to the new home for MySportTrac.com!

    Please click here to find all the info about the move to the new site!

    To access your account you will need to reset your password here

Rear Bumper removal

Thread in 'Exterior' started by Steve, Jan 2, 2019.

  1. Steve

    Steve Member V6 Engine

    Messages:
    1
    Likes Received:
    0
    Joined:
    Jan 2, 2019
    Location:
    So. Cal
    Does someone have a good suggestion for a place to find a schematic / video for the removal of a rear bumper assembly for a 2003 Sport Trac? All I can find is for an Explorer. Any tips or advice is always welcome.
    Thank You.
     
  2. Todd Z

    Todd Z Well-Known Member 2nd Gen Owner V6 Engine V8 Engine

    Messages:
    20,670
    Likes Received:
    104
    Joined:
    Sep 21, 2003
    Location:
    Suffolk County (Long Island), NY
    There is a project in the project section.... BUT remove the step pads, and there are 2 rivits ( 1 each side) you have to cut off with a grinder or dremmel and then it slides off from what I remember....its not that hard...
     

Share This Page