Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
SportTrac Discussion
General Sport Trac Discussion
HERE SHE IS !!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Ford SportTrac Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Jason H" data-source="post: 934875" data-attributes="member: 68786"><p>I removed my fender vents... breaking some clips in the process before figuring out the correct process.</p><p></p><p></p><p></p><p>To start - take a plastic putty knife/blade and run it up and all around the vent breaking the seal of the tape from the vehicle. There are then 4 clips if I remember correctly. Push up - lightly - on the bottom two clips releasing the bottom of the vent. When they are released re run your putty knife up and around the vent (as the tape will have stuck back to the body - just not as heavy as before)</p><p></p><p></p><p></p><p>With the bottom two clips out as you work back up to the top of the vent with the putty knife the top clips should release from the body. The vent will then pull off.</p><p></p><p></p><p></p><p>To replace the vents you will have to clean off all of the tape from both the vent and the body of the vehicle. Then apply fresh tape and clip/tape the vent back on.</p><p></p><p></p><p></p><p>Cleaning the tape off wasn't hard - just time consuming. My vent has been back on the truck with only 2 clips and replacement tape and holding fine. I bought some strong double sided trim tape from the auto store.</p></blockquote><p></p>
[QUOTE="Jason H, post: 934875, member: 68786"] I removed my fender vents... breaking some clips in the process before figuring out the correct process. To start - take a plastic putty knife/blade and run it up and all around the vent breaking the seal of the tape from the vehicle. There are then 4 clips if I remember correctly. Push up - lightly - on the bottom two clips releasing the bottom of the vent. When they are released re run your putty knife up and around the vent (as the tape will have stuck back to the body - just not as heavy as before) With the bottom two clips out as you work back up to the top of the vent with the putty knife the top clips should release from the body. The vent will then pull off. To replace the vents you will have to clean off all of the tape from both the vent and the body of the vehicle. Then apply fresh tape and clip/tape the vent back on. Cleaning the tape off wasn't hard - just time consuming. My vent has been back on the truck with only 2 clips and replacement tape and holding fine. I bought some strong double sided trim tape from the auto store. [/QUOTE]
Insert quotes…
Verification
Post reply
SportTrac Discussion
General Sport Trac Discussion
HERE SHE IS !!!
Top