1. Welcome to the new home for MySportTrac.com!

    Please click here to find all the info about the move to the new site!

    To access your account you will need to reset your password here

Bed Extender Fitment

Thread in 'Help Forum' started by Zee, May 15, 2019.

  1. Zee

    Zee Member 2nd Gen Owner 4 Wheel Drive V8 Engine

    Messages:
    16
    Likes Received:
    1
    Joined:
    May 9, 2019
    Location:
    Phoenixville
    Hello

    I too (along with Memphis Gus) was looking to acquire a bed extender for my Gen 2 (2010). I did find one but I wondered if there were any additional fittings (brackets etc) that were needed? The one I have found is OEM new..
     
  2. kaw900r

    kaw900r Member 2nd Gen Owner 4 Wheel Drive V8 Engine

    Messages:
    79
    Likes Received:
    7
    Joined:
    Feb 12, 2019
    Location:
    On top of duh mountain

    Only need the 2 pins if they are not already on it...
     
    Todd Z likes this.
  3. Todd Z

    Todd Z Well-Known Member 2nd Gen Owner V6 Engine V8 Engine

    Messages:
    20,858
    Likes Received:
    148
    Joined:
    Sep 21, 2003
    Location:
    Suffolk County (Long Island), NY
    Yup, just the two self threading pins for each side of the bed
     

Share This Page