Search results

Update, replaced coil 1, no misfire since

Occasional 301 code, here are the symptoms 2008 V8 110000 miles, replace plugs and 3 coils about a year ago. Sometimes get a rough idle and misfire after about 2 miles, bad enough that the CE light blinks. almost always happens when there is a big change and temperature from warm to cold...

Looking for a NAV / Bluetooth for an 08? Any suggestions?

Same as A1cntrler, 8 plugs(broke 1) 2 coil packs

60k miles and I tow a 23 ft boat with it. Knock on wood, so far nothing, nada, zip , zilch has gone wrong with it. talk about the kiss of death... hope not!

Issues I've had with my 08 V8 now with 105k miles, nothing major I guess Exhaust manifold Plugs and a couple of coil , broke 1 plug Front hub assembly both sides couple of times, need replaced again Radiator replaced

Thanks, if it ever stays warm on the weekend I'll give it a try. I have a replacement, one is cracked but still working.

How difficult is it to remove & install fog lights?

Mine usually takes 15+ when just below 1/4 tank, 17 or more when the warning light says 50 miles remaining. I usually average 14.3 mpg

If it's been in PA long, it probably has rust under the grey cladding under the doors, frame and several other places. Check the spring shackles, if they haven't been replaced they'll need to be probably soon. Body mounts possibly shot plus all the usual items for a 16 yr old "wagon". Be sure...

It's rwd but automatically shifts power to front when rear slips. Use 4wd hi in snow etc. look in the center console for the audio input. Most don't have a need to turn traction control off

Fixed Engine off, key to run, put in reverse. Put my ear next to each sensor, one not making any noise. Got replacement from 1AAUTO, literally a 45 second job. Didn't realize how much I used the park aid until it stopped working.

Replaced the blend door actuator, it works fine now, but now whenever I put the truck in reverse i get the orange "check park aid" message. It doesn't beep if I get too close to anything. Could I have disturbed something while replacing the actuator? I only removed the small panel near my...

Allan, what was the solution ?

Anyone know if this will work?

Info on the wiring harness, where'd you get it, part #s

More info please, been looking for a nav unit for my '08

I'll look used to have one

Mine does not have a door over the hole.