Search results

Ford SportTrac Forum

Help Support Ford SportTrac Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Y

    Opening the 4WD Shift Motor Position Sensor

    2001, gen 1. Does anybody know how to open the 4WD shift motor position sensor? This one is supposedly a third generation, sealed position sensor. As shown in the first image, it does come apart, but when I tried, the outer case started cracking at the "seam" (blue arrow area).
  2. Y

    "Workshop Information" (2001 ST Manual) on CD

    I am looking for a source of the FMC "2001 Workshop Information", or a copy (I somehow cracked mine).
  3. Y

    2001 Service Manual

    I am looking for a source of the FMC "2001 Workshop Information", or a copy (I somehow cracked mine) .
  4. Y

    REVO vs REVO 2

    I've had two sets of the REVO and have liked them on-road and, for the little off-road I do, they are fine. The REVO 2 seems a bit less off-road and more street than the REVO. Anybody use both of these versions and can provide a comparison? REVO REVO 2
  5. Y

    OEM Fog Light Kit Wiring (Mystery Switch ... Thing)

    While getting ready to install the Ford fog light set, I was looking for whatever factory wiring there may be. From what I've read, if the vehicle did not come from the factory with fog lights installed, there is no OEM fog light wiring harness. I confirmed that there is nothing in the engine...
  6. Y

    Needed: Pro Comp Series 98 Wheel, 17x8, 3.5" backspace

    Need to replace my damaged one. Will check eBay, etc.
  7. Y

    Rear Anti-Sway Bar Quick Disconnect

    What are the thoughts of having a quick disconnect on one side only? It seems that there should be no interference with the frame or springs, or binding in the remaining end link, as the suspension can't articulate more than the bump-stops allow. Thinking of a clevis pin with bow-tie...
  8. Y

    A Few Gen1 Console Parts, Base Series

    Base Series, Graphite Hinge assembly Cup holder base Cup holder arm (left, driver, side) Soft storage bag anchor [Broken External Image]: Let me know and I'll send 'em, free for nuthin'.
  9. Y

    Headlight Relay ...

    Please confirm that there are no headlight or High-Low-Flash relays, so I can stop looking. Thank you.
  10. Y

    Center Console - "Snap"

    It finally snapped. Having difficulty determining what comes with the Ford part. Ford has: 3L2Z-78644A22-AAG (armrest assy BASE SERIES, graphite), 6 in the diagram and 3L2Z-78047A20-AAG (armrest assy bracket BASE SERIES, graphite), 7 in the diagram [Broken External Image]...
  11. Y

    FYI - SOHC System

  12. Y

    Those Disintegrating Body Mount Bushings

    Hearing some creaking; it's time to replace the disintegrating body mount bushings. If I recall correctly, the offending bushings are the four sets under the cab area (noted with an asterisk (*), below). Is is sensible to replace all eight sets? I notice that the rear spring bushings are...
  13. Y

    Headlight Vertical Adjust Screw

    Besides buying the entire part (and I think the other side (the pivot adjust screw) will work), where can I get the plastic part? [Broken External Image]:
  14. Y

    Rack & Pinion Shot?

    '01 4WD, 210,000mi. Took it in for balance and rotate, then noticed a little vibration. Took it back and they rebalanced. Vibration turned to steering wheel wobble. Put on rack and could feel a "clunk" in side the rack and pinion assembly. Opinion is that the rack is shot. Manager said...
  15. Y

    Slotted Rotors

    '01 4WD. Looking at PowerSlot and EBC slotted. Anybody have any comments on these or others? Also looking at EBC GreenStuff pads. Thank you, Y
  16. Y

    High Idle When Cold and in Gear

    '01, Job 1, 4x4, 178,000 mi. Started this week. I start it, let it run for a couple of minutes, then "kick it down" a bit to about 1000 RPM. This is a usual. When I put it in gear, the idle raises about 200 RPM. It is fine when at normal running temperature. A/C is off. I was...
  17. Y

    Output Shaft or Bearing

    '01 Job 1, 176,000 miles. I have been trying to diagnose a vibration for over a year. This begins at 77 MPH and continues until I slow-down from fear that something will fly through the floor. I recently re-geared the differentials, which helped localize possible sources (vibration...
  18. Y

    Vehicle Speed Sensor Location ('01, Job 1, 4WD)

    Where is the VSS located? If it's in the transmission and the differentials are re-geared, there should be no change in the tachometer reading at an indicated speed (because there is no change in the relationship between the engine and the transmission), right?
  19. Y

    Differential Noise (New Gears)

    '01, Job 1 4x4. Last week I had the differentials re-geared to compensate for taller tires. When I first drove it, I heard a whining sound from the rear when decelerating. I recognized this as the gears. I engaged the front and heard a similar sound. I called the shop that did the...
  20. Y

    Loud Noise With Light Vibration

    '01 Job 1, 4WD, 170,000 mi. Recently have a loud growling noise similar to a hub (front wheel) bearing noise, but from 35 MHP and above. Sounds kind of like aggressive off-road tire noise. The vibration is high frequency and not severe. It is most noticeable from about 60 to 75 MPH, and...
Top