Search results

Mine is at the Ford dealer now. Did it to me again yesterday after new battery installed.

My '01 has failed to start twice. It would turn over but not start. Both times after the battery had been disconnected. The first time in my garage. I would try starting it every once in a while and finally it cranked right up. The second time was yesterday after I had a new battery...

Thanks Todd. I can check a few things but the rest may be over my head. There might be a roll-back hauler in my future.

I don't drive it much since I retired. Has 60,000 miles. Last time I drove it was Sept. No problems with it. Was going to drive it Saturday and battery was down. It charged up fully and when I tried to start it, it would turn over but not start. I checked all the fuses and the reset button...

Still have my silver Trac. 60,000 miles. I'll have it till I die!!

7 1/2 hrs. for us. Should be there late afternoon Wednesday.

I can't believe this. All these members and we can't even get 7 more to go. Come on folks. There's plenty of you that are closer than I am to Louisville. You might not get this opportunity again.

2001 job 2 4 x 4 29,500

me too

2001 28,000

bump

bump

I have the Kenwood sub and it has plenty of bass for me. It fits perfectly in the storage compartment . I bought a new Pioneer DEH-P680 and I already had Infinity speakers. It sounds great to me. You will save a bunch of money if you get the sub and radio off Ebay.:D

Georgia work boots with steel toes are comfortable.

Thanks guys. I'll stop at Auto Zone tomorrow to get the code and go from there. Darn I hate to have to reset everything on my head unit again.

Replaced the EGR valve, sensor, and IAC valve about a week ago. Now the dad-burn light is on again. I also cleaned the MAF. Any ideas as to what it is this time? Didn't have time to stop and get Auto Zone to check it. I only have 27,900 miles on my trac.

I had the check engine light come on last week. It checked bad EGR valve. I replace it and the sensor too. I cleaned the throttle body and the IAC valve too while I had everything apart. Cranked it up and it ran like new. For a 2001 Job 2 the EGR part number at Auto Zone was EGR 2007 and...

Ok, thanks.

I cleaned the inside with swabs as far as I could get them in but there is a bend in the tube behind the throttle body. I have a new EGR valve to put on but I need to clean the tube good before I install it. Can I just spray throttle body cleaner into it and let it run down into the engine?