Recent content by Wayne Partridge

I just wanted to say thanks for all the great posts. I learned alot. I needed a larger truck so I purchased a 2013 Ford F150 . Sad to let the ST go. Cheers:haveabeer:

Thanks I will look for an aftermarket element not sure how difficult it would be to put in,

same issue at 80 klm I required a new spark plug # 7 seems moisture is a problem as well . Good luck

With winter here would anyone know the way the wires run to the drivers seat ? The switch light works , the passenger side works . I would think the fuse would be ok if passenger side works. Thanks for any help 2007

Love my 2007 but it is time she goes. I need to rent from uHall car trailers can't . Sucks that the dealer made no mention of this. Looking at Ford F150 xtr 4x4 . I prefer the lines of the ST>

Thanks Vic Found this post . Just finished this job, thought I would post my experience. Remove all of the obvious bolts, 2 10mm hold the rails to the rad, 2 14mm hold the rails to the body, 4 10mm for the fan shroud, air dam on the bottom with plastic push fasteners. Also, remove the...

My question was not about a rad cap . It was about installing a rad if there were any practical help from someone who has done it before. This is my first Ford I would prefer no answers than off topic . New rad / Leak from bottom, This is hardly a personal attack. I didn't mean it that way...

yardsale do you have any practical experience in installing a rad or do you just add your worthless 2 cents

Waste of time no practical

I asked this question :My rad is leaking bottom driver side, Bought a new one after 200,000 klm. Would there be any tips before installation. Not sure if I need to take the fan blade off the water pump. Gen 2 v8 thanks . Has anyone other than Eddie done this .

I thought this was good info. 3.Does the overflow tank have too much or too little coolant after vehicle has been run for a while? Under normal circumstances there should be some coolant in your overflow tank after using your vehicle. If you have driven a long distance with almost no coolant...

No leak bottom driver side . Prefer aluminum solid rad no plastic.

Mike good advise would that correct the minor leak I have now ? Goodyear wants 3 hours 273 bucks to install. Going to do myself

Thanks Eddie sounds like an a simple job then of taking off clips . Cheers

My rad is leaking bottom driver side, Bought a new one after 200,000 klm. Would there be any tips before installation. Not sure if I need to take the fan blade off the water pump. Gen 2 v8 thanks