Separate names with a comma.
Welcome to the new home for MySportTrac.com!
Please click here to find all the info about the move to the new site!
To access your account you will need to reset your password here
I can report that this hitch performed flawlessly after towing our 5,000 lb trailer over 3,000 miles. No indication of cracking, bending, etc.
Mine does the same.
Install a Flex shifter. See [MEDIA]
Had the Class II receiver cut out / weld in the Class III receiver yesterday at a local Speed Shop. Enjoy!
[ATTACH] [ATTACH] [ATTACH] [ATTACH]...
2001 Job1 4.0 V6: 274,000
2007 Job1 4.6 V8: 214,000
Both run perfect without leaks or burning oil. The V8 was replaced at a Ford dealer @...
I had correspondence with Gus at Randy's Worldwide, he suggested the relief pocket on the side couplers. He did not mention a notched center pin...
You cannot install a Spartan Locker in an 8.8 IRS without modification to the side couplers.
You have to cut 0.100"...
Right, the bent down tabs in the 4th picture face forward, as shown in this...
This is a simple replacement on 2WD Gen2 Sport Tracs, replacement bearing is Ford 7A2Z-4A499-A Bracket. The driveshafts can be disconnected by 1...
I redid mine with fiberglass and epoxy two years ago and it still looks great. The design on these enables water/salt to enter the top holes,...
This is what a Spartan Locker looks like after 15,000 miles in my 2001 Sport Trac RWD. Over a third of those miles were towing a 5,000 lb boat....
OK, like this then? 2" weld on receiver is Curt 49060, 6" long.
Anyone have pictures of this 2" square hitch receiver blank weld on to upgrade the 1 1/4" Class II receiver on a 2007+ Sport Trac?
Use only Mercon V in the 5R55E transmission.