Recent content by dave moore

I changed both of the valve body gaskets and inspected the servos and valves. The servos and valves were scuff free without signs of build up. After reinstalling the flaring is completely gone. It has been good for 5 days and hundreds of miles now. Thanks for everyone's advice... It paid off...

On one door, I was able to put some pressure on the door lock knob to position the servo bracket on the inside of the door frame. This allowed me to simply insert the pop rivet without removing the door panel. The driver's door however, was completely a different experience. I had to remove...

On one door, I was able to put some pressure on the door lock knob to position the servo bracket on the inside of the door frame. This allowed me to simply insert the pop rivet without removing the door panel. The driver's door however, was completely a different experience. I had to remove...

On one door, I was able to put some pressure on the door lock knob to position the servo bracket on the inside of the door frame. This allowed me to simply insert the pop rivet without removing the door panel. The driver's door however, was completely a different experience. I had to remove...

On one door, I was able to put some pressure on the door lock knob to position the servo bracket on the inside of the door frame. This allowed me to simply insert the pop rivet without removing the door panel. The driver's door however, was completely a different experience. I had to remove...

It drove good today, only mild 1-2 flair under medium-hard acceleration. But, the flashing OD started, so I pulled over and shut the engine off for a minute. After I started up again, the OD light did not flash at all. Hopefully the Valve Body Gasket and transmission repair manual that I...

I changed the filter, Adjusted the EPC, retrofitted an oil pan drain plug, and added fully synthetic Mercon V. I was unable to obtain a new valve body gasket today. It no longer flairs at all with light throttle and flairs about 50% less with medium throttle. I think I'll give it a day...

Thanks guys. I unplugged the battery for 30 minutes which didn't change anything. I just purchased a filter and synthetic Mercon V. I have to find a local parts store that has an upgraded valve body gasket and transmission pan drain plug retrofit in stock. Luckily. it's 70+ degrees in the...

Thanks guys. I unplugged the battery for 30 minutes which didn't change anything. I just purchased a filter and synthetic Mercon V. I have to find a local parts store that has an upgraded valve body gasket and transmission pan drain plug retrofit in stock. Luckily. it's 70+ degrees in the...

Thanks guys. I unplugged the battery for 30 minutes which didn't change anything. I just purchased a filter and synthetic Mercon V. I have to find a local parts store that has an upgraded valve body gasket and transmission pan drain plug retrofit in stock. Luckily. it's 70+ degrees in the...

My 2001 4x2 with tow package and 157,00 miles slips/flares when shifting from 1st to 2nd gear. This is more noticeable when the engine is cold or with harder acceleration. It seems less noticeable but present when the motor is warm. I last had the transmission serviced at the dealer around...

It is not the steering column as the other rear and both front signals work fine

Does anyone know of a wiring diagram schematic for the rear taillights with a 2001 that has the factory 4 pin trailer wiring? My right rear turn signal and emergency flasher doesn't work but my running and brake lights do. Its not the bulb and on my 4 pin trailer connector, the right turn and...

Does anyone know of a wiring diagram schematic for the rear taillights with a 2001 that has the factory 4 pin trailer wiring? My right rear turn signal and emergency flasher doesn't work but my running and brake lights do. Its not the bulb and on my 4 pin trailer connector, the right turn and...